Services

State Of The Art Nodes For Recording

Master/Slave/Repeater Modes
Weight Drop Mode can be used to synchronize Impulse Seismic Sources like the DigiPulse
Compatible with SSC Universal Encoder, Pelton Advance TM II, Vib Pro TM, or Shot Pro TM Encoders
PC software provides easy to use graphical interface to all shot information

Accurate and repeatable shot firing accuracy +/- 20 usec
Automatic Radio Start Time adjusted to ensure the quality of production
PC software displays, stores, and exports all shot information, including Uphole Time, GPS, and start time error
Safety-Triple protection against accidental CAP firing

Arm switch - shorts CAP lines unless the switch is held in the ARM position
Charge switch - High Voltage is disconnected from CAP lines unless the switch is held in the charge position
DSP control - High Voltage is not connected to CAP lines unless commanded by the Digital Signal Processor

CAP and Geophone test
Reduced dead time for the start command
Simple and reliable single-board construction
Same lightweight unit used for Encoder and Decoder
Low Power with auto-sleep mode for longer battery life
Digital Interface to all major recording systems
DSP technology for accurate uphole geophone recording and processing
Decoder Unit can trigger an Air Gun Controller
State of the Art Phase and Force Control
Integrated GPS
24-bit Vibrator Signature Option (HFVS TM)
Linear, Non-Linear, and Custom Sweep capabilities
Rugged Design
Vibrator Calibration - Quick and Easy - allows electronics to quickly be switched to a new vibrator without long setup time
Post Sweep Report - Quality Control report at the end of the sweep. Includes Phase Error, Force Output, GPS, and other QC information
Uses standard 41-pin interface cable compatible with most vibrators

Force Two Vibrator Decoder Units - The new radio interface and control system allow direct replacement of Pelton Vib Pro TM Units.

Force-Two control units can operate in the same vibrator group as the Pelton Vib Pro TM Unit
Force-Two generates the same sweep as Pelton Vib Pro TM Units
Force-Two unit uses the same Start Code and PSS type as the Pelton Vib Pro TM Unit
Force-Two has the same PPS data as the Pelton Vib Pro TM Unit
Force-Two uses the same Vibrator Wiring as the Pelton Vib Pro TM Unit
Force-Two can also use the Advance II Start code for more reliable telemetry